Start-up & commissioning for wet gas and wellhead flow measurement
Global on-site commissioning services for on- and offshore multiphase and wet gas systems
- Start-up of equipment, and assistance in performing wellhead and wet gas measurements
- Assurance of smooth and continuous operation in the field
- Training for operators, engineering and maintenance personnel
KROHNE’s multiphase and wet gas measurement systems are designed to start up from the moment they are powered-up and settings can be altered through intuitive interfaces. However, it is recommended to have a service engineer on site during start-up and commissioning. Being experts in both multiphase and system engineering, the KROHNE engineers can combine start-up and commissioning with potential troubleshooting and service and operator training on-site.
The KROHNE engineer assists in defining the optimum settings and workflow for well tests, resulting in significant saving in operating costs over the lifetime of the equipment. KROHNE has a local presence in over 100 countries and can therefore guarantee a global availability of our on-site commissioning services.
Product highlights
- Kick-off meetings for execution planning
- Inspection of instrumentation and communication from the field to the control room
- Assistance in start-up of the wellhead and wet gas measurement systems
- Support by experienced engineers with offshore certification where required
- Advice in defining workflow for well tests, with a focus on savings in operating costs
Typical applications
- Multiphase flow measurement directly at the wellhead
- Measurement of mixtures of crude oil or condensate with natural gas and water
- Well testing applications and periodic production testing
- Single well surveillance and well monitoring for production optimisation and flow assurance
- Allocation measurement in tie-back lines
Related solutions
Wellhead flow measurement
Coriolis based solutions for single phase and multiphase measurement
- For liquid and gas mixtures
- Net-oil and watercut measurement
- Direct measurement on the wellhead
- Meter maintains operation over a wide range of gas fractions and complex flow conditions
WGS Wet gas measurement
Highly flexible and economical solution for well performance optimisation
- Venturi based metering systems for wet gas (gas volume fraction 90...99%)
- Well performance verification and well management
- Smart diagnostics and system fault monitoring
Related services
Consultancy & engineering for wet gas and wellhead flow measurement
Selection and design of the optimal single phase or multiphase solution
- Consultancy regarding the most suitable measurement solution
- Cost effective engineering concepts tailored to the application and installation
- Detailed design of mechanical set-up, instrumentation, E&I and software
- System architecture tailored to the project requirements
System calibration & validation for wet gas and wellhead flow measurement
Achieving full performance in the field with reliable measurements
- Optimisation of the system according to application requirements
- Remote technical assistance by KROHNE experts
- Test plans and comparison of results
- Intuitive input of fluid properties for wet gas measurement systems
- Field validation of measurement performance
Operation & maintenance for wet gas and wellhead flow measurement
Maintaining field operations at peak performance without compromise
- Support for operators in performing well production measurements
- Maintenance contracts and service level agreements
- Pre-defined service rates and response times
- 24/7 Customer support and emergency helpdesk
- Periodic health checks and software updates